Dreame L10s Ultra Gen 3 Robot Vacuum and Mop

The frequency depends on your cleaning usage. The app will notify you when the dirty water tank is full and requires emptying. For regular use, plan to empty it every 2-3 cleaning cycles.

Yes, the L10s Ultra Gen 3 is designed to vacuum and mop simultaneously, providing a comprehensive clean in a single pass.

The robot is equipped with a high-capacity battery designed to cover large areas on a single charge. It will automatically return to the dock to recharge when necessary and resume cleaning from where it left off.

The PowerDock™ automatically washes the mop pads with clean water and then extracts the dirty water after each cleaning session or when the mopping coverage reaches a certain area. It also dries the mop pads to prevent odors.

The robot is equipped with cliff sensors to prevent falls down stairs. However, it cannot climb stairs and should not be relied upon for multi-level cleaning without manual intervention.

Gently wipe all external sensors, including cliff sensors, wall sensors, and obstacle avoidance sensors, with a clean, dry, soft cloth. Avoid using abrasive materials or cleaning solutions.

Only use clean water in the water tank. The manufacturer does not recommend using any cleaning solutions or detergents, as they can damage the mopping system and dock.

Ensure the dock is powered on and has adequate space around it. Check if the robot's charging contacts and the dock's contacts are clean. Restart the robot and the dock.

Check if the clean water tank is sufficiently filled and the dirty water tank is not full. Ensure the mop pads are properly attached and clean. Adjust the water flow level in the app if necessary.

Verify that the dustbin is not full and the filters are clean. Check the main brush and side brush for tangled hair or debris. Ensure the suction power setting is appropriate for the floor type.

Confirm your Wi-Fi network is 2.4GHz and stable. Restart your router and the robot vacuum. Try re-pairing the device through the app.

Ensure the dust collection port on the dock and the robot are clear of obstructions. Check if the dust bag in the dock needs replacement. Restart the dock.