Hotpoint Condenser Tumble Dryer - White - B

Clean the fluff filter after every drying cycle to maintain optimal performance and drying times.

Open the door and pull out the water tank. Empty the water into a sink or drain, then replace the tank.

No, this is a condenser dryer; it does not require external venting. It collects water in a tank that needs to be emptied.

Ensure you have selected the correct drying program and that the dryer is not overloaded. Check and clean the fluff filter.

Select the desired drying program, then use the delay start function to set a time for the cycle to begin.

The water tank is typically located at the top or bottom of the dryer, accessible from the front.

The Rapid Cycle is used for quickly drying small loads or individual items when you need them in a hurry.

The Refresh Cycle is designed to freshen up clothes that have been stored for a while or lightly worn, removing odors and wrinkles.

Check that the dryer is plugged in and the power outlet is working. Ensure the door is fully closed.

Check the fluff filter and clean if necessary. Ensure the water tank is not full. Select the correct drying program for the load.

Make sure the fluff filter is clean. Do not overload the dryer. Ensure the room is well-ventilated.

Ensure that the dryer is level so that the water can drain properly. Check the condenser unit for any obstruction and clean.

Stop the dryer and check for trapped items (buttons, coins) inside the drum. Contact customer support if the noise persists.