Loops SDS Plus Drill Bit - 13mm x 450mm

SDS Plus (Slotted Drive System) is a type of chuck system used on rotary hammer drills, designed for efficient bit mounting and power transfer. This bit is specifically made for SDS Plus chucks.

This bit is ideal for drilling into concrete, masonry, brick, stone, and other hard, brittle materials.

No, this bit requires a hammer drill with an SDS Plus chuck. It is not compatible with standard drills that have a three-jaw chuck.

After use, clean the bit with a stiff brush to remove dust and debris from the flutes. Avoid using water unless absolutely necessary, and ensure the bit is thoroughly dried afterward.

A fully hardened bit offers increased durability and resistance to wear, while ground flutes ensure precision and efficient material removal, leading to cleaner holes and longer bit life.

The lifespan depends on the material being drilled, the type of hammer drill used, and proper usage. However, its hardened and ground construction is designed for extended durability compared to standard bits.

Ensure the SDS Plus shank is clean and free of debris. Make sure the chuck is fully open and the bit is inserted completely before closing the chuck.

Verify you are using the correct drilling mode (hammer drill) on your machine. Ensure the material being drilled is compatible with this type of bit. Check if the bit is dull or damaged; consider replacement if necessary.

Allow the drill bit to cool periodically during prolonged use. Ensure adequate lubrication if recommended for the specific material and drilling task.