Trend Plug Cutter & Countersink Set - SNAP/PC/A

This set is designed for use with No. 8 (9.5mm) and No. 10 (12.7mm) screws.

It is recommended to use a pillar drill for the best results and control.

The plug cutters are made from Tool Steel.

You can carefully drill out the plug, being cautious not to damage the surrounding wood. Alternatively, use a chisel to gently pry it out.

Clean the bits after each use to remove any wood residue. Store them in a dry place to prevent rust. Sharpen the cutters when necessary.

Yes, this set can be used with hardwoods. However, using a lower drill speed is recommended to prevent burning the wood.

The chamfer helps the plug cutter start its cut easily and ensures the plug has a slightly tapered edge for a better fit.

Ensure the correct plug cutter size matches the countersink and screw size. Check for any wood debris in the hole or on the plug. Check if the drill is perpendicular to the wood surface while drilling.

Use a wood glue with the plug. Ensure the wood is not too dry. Apply gentle pressure during insertion.

Check the sharpness of the countersink. Increase the drill speed, but not too much.