Best current price£122.90from Vevor UK
Shopping.co.uk recommended and popular offers
Vevor UK£122.90Visit shop VEVOR Pneumatic Staple Gun, 16 Gauge 26.4mm Wide Crown Pneumatic Stapler 16mm to 38mm Length, 70-120PSI Air Staple Gun with Two Firing Modes for Roof Decking, Wall Sheathing, Fencing, Subflooring
Visit shop1 offer from £122.90
View price history by clicking the chart icon.
The VEVOR 16-gauge pneumatic staple gun (PW2638-L) is a heavy-duty fastening tool designed for professional contractors and serious DIYers involved in framing, roofing, and subflooring projects. Its primary benefit is the high-capacity magazine and dual firing modes, which significantly increase efficiency during repetitive fastening tasks; however, users should be aware that it requires an external air compressor to operate, which is not included in the package.
| Model Part Number | PW2638-L |
|---|---|
| Brand | VEVOR |
It uses 16-gauge wide crown staples with a crown width of 1 inch (26.4 mm) and lengths between 5/8 and 1-1/2 inches.
No, the air compressor is not included and must be purchased separately.
The tool operates optimally at a pressure between 70 and 120 PSI.
This tool is designed for heavy-duty framing and sheathing. It is likely too powerful and bulky for delicate upholstery work.
The tool utilizes a standard 1/4 inch NPT air inlet.
Consult the included manual for your specific model's selector switch location, usually found near the trigger assembly.
Adjust the air compressor regulator to increase pressure (ensure it stays under 120 PSI) or check if the fastener length is appropriate for the material thickness.
Disconnect the air supply immediately, open the quick-release nose mechanism, remove the bent or jammed staple, and ensure the magazine channel is clear of debris.
Check all fitting connections at the air inlet. If the leak persists, inspect the internal O-rings for wear and tear, and replace if necessary.
To set up the tool, ensure your air compressor is turned off and disconnected. Connect your air hose to the 1/4 inch NPT air inlet on the tool, ensuring the connection is airtight. Slide the staple strip into the magazine until it locks into place.
Compatibility: This tool accepts 16-gauge staples with a 1-inch crown and lengths between 5/8 and 1-1/2 inches.
Care Instructions: Regularly lubricate the tool with a few drops of pneumatic tool oil via the air inlet before each use. Check the magazine for debris buildup weekly. If the tool sits unused for long periods, store it in a dry, dust-free environment to prevent corrosion of the internal piston components.
