Ronseal Decking Stain - Grey - 2.5 Litre

2.5 litres of Ronseal Ultimate Protection Decking Stain covers approximately 16 m² (6.4 m² per litre), assuming one coat. Actual coverage may vary depending on the porosity and condition of the wood.

This stain is designed for bare or previously stained decking. For best results, remove any old paint or varnish completely before application.

Clean the stained deck using a stiff brush and water. Avoid using strong detergents or abrasive cleaners, as these can damage the protective finish.

Ronseal Ultimate Protection Decking Stain offers double the weather resistance and foot traffic protection compared to standard decking oils, providing extended durability. Specific longevity depends on environmental factors and usage.

It is recommended to apply the stain when the temperature is between 5°C and 25°C and when there is no risk of frost or rain.

No, this stain provides a lightly tinted finish that enhances the natural beauty of the wood grain rather than completely obscuring it.

Ensure the stain was thoroughly stirred before and during application. Apply in thin, even coats and avoid over-application or leaving puddles. Ensure consistent brush strokes in the direction of the wood grain.

Drying times can be affected by humidity and temperature. Ensure application is within the recommended temperature range (typically 5-25°C). High humidity can slow drying. Avoid applying in direct, hot sunlight or in damp conditions.

The final colour can vary depending on the type and condition of the wood. Test the stain on an inconspicuous area first to gauge the final appearance. Two coats will result in a darker, richer colour than one coat.

This is a sign the stain is working correctly and providing water repellency. Allow the stain to fully cure; water repellency may increase over the first few days.