Living and Home 3D Rectangle Straight Pattern Self-Adhesive Wall Tile Stickers - Grey - Striped

While these stickers are water-resistant, they are not recommended for direct, prolonged exposure to water, such as inside a shower. Use them in areas where they will be less exposed to direct water.

Gently heat the sticker with a hairdryer on a low setting to soften the adhesive. Then, slowly peel from one corner. Be cautious to avoid damaging the wall. Some adhesive residue may remain; it can be removed with a mild adhesive remover.

Yes, but only if the existing tiles are smooth, clean, and flat. Ensure that the surface is properly cleaned before applying the stickers.

They can withstand moderate heat. However, avoid applying them directly behind a stovetop or near a heat source that produces excessive heat.

Use a utility knife or sharp scissors to cut the stickers to the desired size and shape. Measure carefully before cutting.

You can carefully peel off the sticker and reposition it within a few minutes of application. Try to do this before the adhesive fully sets.

The pattern repeat will depend on the installation. Ensure to match the pattern when applying the stickers to achieve the desired effect. If you have an irregular wall, be sure to pre-plan the sticker layout to minimize cuts and waste.

Ensure the wall surface is clean, dry, and smooth. Reapply the sticker, pressing firmly, especially at the edges. Consider using a heat gun or hair dryer on a low setting to activate the adhesive if needed.

Gently lift the sticker and smooth out the bubbles with a soft cloth or a squeegee. Use a pin to prick any persistent bubbles and smooth them out.

Press the edges firmly again to ensure they adhere to the wall. Use a hairdryer on a low setting to warm the edges if necessary.