Toolty Sponge Grouting Float - Tiling Finishing Tool - 280X140X25mm - TLTY-3677

Clean the sponge after each use or whenever it becomes clogged with material.

No, it is not recommended to use this float on painted surfaces.

You can use this float on plaster, cement, tiles, and mosaics.

The sponge is firmly attached to the handle via adhesive, so the whole tool would need replacing. Alternatively, you can attempt to replace the sponge by removing the old one and gluing a new one with a suitable adhesive.

The Toolty Sponge Float is available in 11.02" (280mm) x 5.51" (140mm) with a thickness of either 1" (25mm) or 1.18" (30mm).

Yes, a set of 3 Toolty Sponge Floats is available.

Replace the sponge or the entire float. Ensure the sponge is not being used on overly rough surfaces or with excessive force.

Ensure your hand is positioned correctly on the handle. If discomfort persists, consider wearing gloves.

Ensure the sponge is damp but not soaking wet. Apply even pressure and use consistent strokes. The angle of the float is important for smoothing the surface. Practice and adjust your technique.