Best current price£38.11from www.lindy.co.uk
Shopping.co.uk recommended and popular offers
www.lindy.co.uk£38.11Visit shop 19" CAT5e 1U 16 Port RJ-45 Patch Panel, Unshielded, Black
Visit shop1 offer from £38.11
View price history by clicking the chart icon.
This Lindy 19" CAT5e 1U 16 Port RJ-45 Patch Panel is designed for network administrators and IT professionals looking to organize and terminate network cabling efficiently. Its key benefit is providing a high-density, rack-mountable solution for up to 16 network connections, supporting 10 Gigabit Ethernet. A minor consideration is that mounting screws and cage nuts are sold separately.
| Model Part Number | 20755 |
|---|---|
| Brand | Lindy |
This patch panel supports solid core wire gauges from 22 AWG to 26 AWG.
The product specifications do not mention PoE support. This panel is designed for data transmission and is unshielded, so PoE compatibility is not a primary feature.
No, punchdown tools are not included with this patch panel. You will need a compatible Krone or 110 style punchdown tool for installation.
T568A and T568B are two different wiring standards for Ethernet cables. While they use the same RJ-45 connector, the order of the eight wires is different. Consistency is key; use the same standard at both ends of a cable run for straight-through connections. This panel supports both for flexibility.
Yes, while designed for Cat6, this patch panel is backward compatible with Cat5e cables. However, to achieve the full 10 Gigabit Ethernet speeds, Cat6 or higher cabling is recommended.
The patch panel has a 1U rack capacity, meaning it occupies one rack unit (approximately 1.75 inches or 44.45 mm) in height. It is designed for a standard 19-inch wide rack.
Mounting screws, cage nuts, and washers are supplied separately under Part No. 66034. Please refer to Lindy's catalog or contact their support for purchasing information.
Verify that the wires are correctly punched down according to the T568A/T568B color code. Ensure the wire is securely seated in the terminal block. Check the patch cable connection at both ends.
Confirm that Cat6 cables are used for both the runs to the patch panel and the patch cords. Ensure the punchdown termination is clean and not causing signal degradation. Verify that the connected switch port supports the desired speed (e.g., 10Gbps).
Ensure you are using a standard 19-inch server rack. Confirm that the rack has sufficient vertical space for a 1U device. Check if any adjacent equipment is obstructing the mounting points.
Ensure you are using the correct type of punchdown tool (Krone or 110) for the terminal blocks. Make sure the wire insulation is stripped correctly, not too much or too little. Ensure the tool is properly seated on the terminal.
Setup:
Compatibility:
Care:
