Stanley Roller Refill - Long Pile Polyester - 230mm

This roller refill is best suited for semi-rough and rough surfaces such as textured plaster, render, brickwork, and concrete.

While primarily designed for emulsion and masonry paints, it can be used with some solvent-based paints. However, for high-gloss finishes on smooth surfaces, a short-pile or foam roller might provide a better result.

For water-based paints, rinse immediately with warm water until clean and allow to air dry. For solvent-based paints, use the recommended solvent for cleaning and dry thoroughly.

The pile height of this roller refill is 18mm.

No, this is a roller refill only and requires a compatible 230mm roller frame to be used.

With proper cleaning and care, the durable polyester fabric should provide good performance for multiple projects, especially when used with compatible paints and surfaces.

Ensure the roller is fully saturated with paint. Check for any loose fibers on the roller; trim if necessary. The surface may be too smooth for the long pile; consider a short pile roller for very smooth finishes.

Verify that the roller frame spindle diameter is compatible (usually 8mm) and that the roller refill is pushed on completely. Ensure the frame itself is not damaged.

Ensure the roller is thoroughly cleaned and dry before use. If the roller is old or worn, it may need replacement. Ensure you are loading enough paint onto the roller from the tray.