Kenable Network Cable - Cat5e

Cat6 cables generally support higher frequencies and offer better performance, especially for Gigabit Ethernet and beyond, often featuring tighter twists and better shielding than Cat5e. Cat5e is sufficient for most standard home and office network speeds up to 1 Gbps.

Due to its Copper Clad Aluminium (CCA) construction, this cable is not recommended for Power over Ethernet (PoE) applications. CCA is less conductive than pure copper, which can lead to overheating and reduced efficiency when carrying significant electrical current alongside data.

UTP stands for Unshielded Twisted Pair. It means the cable consists of pairs of wires twisted together without an overall metallic shield to protect against electromagnetic interference. This is common for shorter runs in less interference-prone environments.

While Cat5e is rated for up to 100 meters, the CCA construction in this specific cable might lead to increased signal degradation over longer runs compared to pure copper cables. For distances approaching 100 meters, a pure copper cable is generally recommended for optimal performance.

Connect one end to the Ethernet port on your device (like a computer or game console) and the other end to an available Ethernet port on your router or network switch. It's a plug-and-play connection.

Moulded connectors offer increased durability and strain relief compared to connectors that are crimped onto the cable jacket. They are less likely to break or detach under normal use.

The blue colour is primarily for identification. It helps distinguish this cable from other cables (e.g., power cords, other network cables) in a complex setup, aiding in network management and troubleshooting.

Ensure both ends of the cable are securely plugged into the correct ports on your device and router/switch. Try a different Ethernet port on your router or switch. Test the cable with a different device to rule out a device-specific issue. Check if the network adapter settings on your computer are enabled.

Check for any visible damage to the cable or connectors. Ensure the cable is not bent at a sharp angle or excessively stretched. Try replacing the cable with a known good one, preferably pure copper, to see if performance improves. Reboot your router and connected device. Clean the RJ45 connectors gently.

Inspect the RJ45 connector for damage or debris. Ensure you are using an Ethernet port and not a phone jack (which uses a similar but smaller connector). The clip on the connector might be broken; if so, the cable may need replacement.