Dry Lining Plasterboard Back Box Pattress Box - 1 Gang - 47mm - kenable

This back box is specifically designed for drylining or plasterboard walls. It uses clip-in mechanisms that grip the back of the plasterboard.

The mounting depth of this specific model (004638) is 47mm.

No, this is a single gang (1G) back box and is designed for single faceplates only. It is not compatible with double-width faceplates.

This product listing is for the back box itself. Screws for mounting the faceplate are typically included with the faceplate, not the back box.

No, this back box is intended for indoor use within drylining walls and does not have any weatherproofing ratings.

This back box conforms to BS5733 standards, ensuring it meets safety and performance requirements for electrical accessories.

Yes, kenable offers this type of back box in alternative depths (e.g., 35mm) and configurations (e.g., 2 gang).

Ensure the opening in the plasterboard is the correct size for the back box. Check that the spring clips are fully engaged with the rear of the plasterboard. If the plasterboard is weak, consider using alternative fixing methods or reinforcing the area.

Verify that the back box is installed flush with the wall surface. Ensure the correct screw holes are being used on the faceplate. Trim any excess plasterboard if it is obstructing the faceplate.

Slightly adjust the size of the wall opening. Ensure there are no obstructions within the opening. Gently ease the back box into place, allowing the clips to engage.