Connect Overbraided Fuel Line Hose - 7.0mm ID - 5m

This hose is manufactured to be resistant to oil and fuel, suitable for standard gasoline and diesel. For specific or high-performance fuels, always verify compatibility with the manufacturer's guidelines.

This hose is designed for standard fuel line applications and is not rated for high-pressure fuel injection systems. Please consult specific product ratings for high-pressure requirements.

Use a sharp, dedicated hose cutter or a very sharp blade for a clean, precise cut. A dull tool can crush the hose, affecting its ability to seal properly.

The overbraiding provides an additional layer of protection against abrasion, wear, and minor impacts, helping to extend the service life of the hose in demanding environments.

While primarily designed for fuel, its oil resistance and temperature range might make it suitable for other low-pressure fluid transfer applications. However, always confirm fluid compatibility before use.

The primary differences are typically in the inner diameter (ID) and sometimes the length or specific construction details. This model has a 7.0mm ID and is 5 meters long, complying with DIN 73379 Type B.

This is normal at low temperatures due to the rubber compound. Allow the hose to warm to ambient temperature before attempting to route or install it.

Check that the hose clamps are tightened securely and that the hose is fully seated onto the fitting. Inspect the hose end for any cracks or damage.

This may indicate incompatibility with the fuel being used. Inspect the hose for specific material degradation and replace if necessary. Consult product specifications for confirmed fluid compatibility.

Ensure the hose is not rubbing against sharp or abrasive surfaces. Re-route the hose or protect it with additional abrasion-resistant sleeving if necessary. Continue to monitor for wear.