Paint Factory Auto Extreme Clear Lacquer - 400ml

The surface should be thoroughly cleaned, degreased, and dried. Any existing paint should be lightly sanded for adhesion, and all dust removed. For automotive applications, proper priming is essential.

It is generally recommended to apply 2-3 thin, even coats, allowing adequate drying time between each. The number of coats can vary depending on the desired level of protection and gloss.

Drying times can vary based on temperature, humidity, and application thickness. Typically, it is touch-dry within 15-30 minutes and fully cured within 24 hours, though recoating is usually possible after 1-2 hours.

Yes, once fully cured, the high-gloss finish can be polished and buffed using standard automotive polishing compounds to achieve an even higher shine or remove minor imperfections.

It can be used on many types of plastic, but it's always advisable to test on a small, inconspicuous area first to ensure compatibility and to avoid any adverse reactions like melting or clouding.

Always use in a well-ventilated area, wear appropriate personal protective equipment including gloves and eye protection, and avoid inhaling spray mist. Keep away from heat and open flames.

Ensure the can is held at a consistent distance and moved steadily. Apply in thinner coats rather than one heavy coat. Check temperature and humidity conditions, as extreme conditions can affect drying.

This can occur if applied in humid conditions or if the surface was not properly prepared (e.g., moisture or contaminants). Ensure adequate ventilation and a clean, dry application surface. Allow sufficient drying time between coats.

The lacquer was likely applied too thickly or too close to the surface. Allow the drips to dry completely, then gently sand them down with fine-grit sandpaper and reapply in thin, even coats.

After use, always turn the can upside down and spray briefly to clear the nozzle. If already clogged, try soaking the nozzle in a suitable solvent (check product recommendations or manufacturer's website) and then clear with a fine pin.