Best current price£475.00from B&Q
Shopping.co.uk recommended and popular offers
B&Q£475.00Visit shop - Matt Grey Slate Effect Chamfered Straight Edge Solid Core Laminate Worktop (T) 1.2Cm X (L) 300Cm X (W) 38Cm
Visit shop1 offer from £475.00
View price history by clicking the chart icon.
This B&Q Grey Slate Effect Laminate Worktop is designed for homeowners undertaking kitchen or bathroom renovations seeking a realistic, low-maintenance surface. Its key benefit is the highly accurate slate effect with a chamfered edge, offering a premium look without the cost or upkeep of natural stone. A potential caveat is that, like all laminate, it requires careful handling during installation to avoid damage to the edges or surface.
| Brand | B&Q |
|---|
No, it is not recommended to place hot pans directly on the laminate surface as it can cause scorching or damage. Always use trivets or heat-resistant mats.
Use a fine-toothed saw and a guide for straight cuts. Router tools can be used for sink or hob cut-outs. Ensure all cut edges are sealed with a laminate sealant.
The laminate surface is water-resistant, but the core material is not waterproof. It is essential to seal all cut edges and joints properly to prevent moisture from seeping in, especially in areas like kitchens and bathrooms.
Clean spills promptly with a soft, damp cloth and a mild, non-abrasive detergent. Wipe dry afterwards. Avoid harsh chemicals or abrasive cleaning pads.
Yes, this worktop is suitable for bathroom use due to its water-resistant surface. However, ensure proper sealing of edges and avoid prolonged exposure to standing water.
A chamfered edge is a beveled or angled edge, typically at a 45-degree angle. This provides a clean, modern look and can feel smoother than a sharp, square edge.
Minor scratches can sometimes be buffed out with a non-abrasive cleaner and a soft cloth. For deeper scratches, consider a laminate repair kit or professional resurfacing.
Ensure cut edges were properly sealed during installation. For minor damage, a laminate repair pen or filler might be suitable. Significant damage may require edge banding or replacement of the section.
These are typically scorch marks. If superficial, try a specialized laminate cleaner. Deeper scorch marks are difficult to remove and may require professional attention or replacement.
This usually indicates moisture ingress. Ensure all cut edges and joints are properly sealed and that the worktop is not exposed to standing water. If severe, the affected section may need replacement.
Setup:
This worktop is designed to be cut to size using appropriate woodworking tools. It is recommended to use a fine-toothed saw and a guide to ensure clean, straight cuts. When joining sections, use a suitable adhesive and worktop connector system designed for laminate surfaces. Ensure all cut edges are properly sealed with a laminate sealant to prevent moisture absorption, especially in areas prone to humidity.
Compatibility:
Compatible with standard kitchen cabinets and bathroom vanity units. Ensure your base units are level and provide adequate support for the worktop. Sink and hob cut-outs should be made using templates and appropriate routing equipment, with edges sealed immediately after cutting.
Care:
Clean spills immediately with a soft, damp cloth and mild detergent. Avoid abrasive cleaners, scouring pads, or harsh chemicals, as these can damage the laminate surface. Use trivets or heat-resistant mats under hot items and chopping boards for cutting to prevent scratches and scorch marks. Wipe dry with a clean cloth after cleaning.
