FloPlast Floguard Gutter Guard - Twin Pack

Floguard is a reliable leaf barrier designed to prevent debris from clogging your gutter system wh...

Best current price£49.19from Professional Building Supplies

All Offers

2 offers from £49.19 - £62.04

View price history by clicking the chart icon.

Professional Building SuppliesFloplast Floguard Gutter Guard - Twin Pack
Free delivery in 1–3 days
£49.19
Visit shop
B&QB&Q - Floguard Gutter Guard Twin Pack Fits 100mm To115mm Gutter
Free delivery in 1–3 days
£62.04
Visit shop

Product Information

Full details

The FloPlast Floguard Gutter Guard is designed for homeowners and DIY enthusiasts looking to minimize gutter maintenance by preventing leaves and debris from clogging downpipes. Its primary benefit is the maintenance of full gutter capacity through a debris-filtering mesh, though users should note it is specifically engineered for gutter widths between 100mm and 115mm, necessitating precise measurement before purchase.

All features

Model Part NumberFG1PACK
BrandFloPlast

Extended Product Information

FAQs

Do I need screws to install the Floguard?

No, the Floguard uses a simple clip-together mechanism that requires no screws or drilling.

Which gutter profiles is this compatible with?

It is compatible with most Half Round, Square, and Deepflow gutter profiles.

Is this suitable for 120mm gutters?

No, the Floguard is specifically designed for gutter widths between 100mm and 115mm.

What is the British Standard Kitemark?

It is a quality mark that indicates the product has been tested to meet specific British safety and performance standards.

How often should I clean the guard?

It is recommended to inspect and brush off any surface debris at least twice a year.

Does this prevent small particles like pine needles?

The Floguard is designed for larger debris like leaves and moss; very fine needles may occasionally pass through the mesh.

Troubleshooting

Guard does not fit gutter width

Verify your gutter measures between 100mm and 115mm; the product is not compatible with systems outside this range.

Guard feels loose after installation

Ensure the clips are pressed firmly until an audible click is heard and that they are seated fully against the gutter edge.

Water flowing over the top of the guard

Check that the guttering is not already blocked underneath the guard or that the downpipe is not obstructed at ground level.

Pros and Cons

Pros

  • Tool-free installation saves time and labor
  • Compatible with major gutter profiles like Square and Deepflow
  • Maintains drainage efficiency by preventing blockages
  • Certified quality with British Standard Kitemark

Cons

  • Limited to gutter widths between 100mm and 115mm
  • Not suitable for non-standard or oversized gutter systems
  • May require periodic manual clearing of surface debris

Setup, Compatibility & Care

Before installation, ensure your existing guttering is clear of all debris to provide a clean base. The Floguard sections are installed by simply clipping them onto the gutter edge; ensure each clip is fully engaged to prevent wind displacement. The system is compatible with most major brands of Half Round, Square, and Deepflow gutters provided the width is between 100mm and 115mm. For care, visually inspect the guards twice a year—ideally before and after the autumn season—to brush off any accumulated surface debris that may have gathered on top of the mesh.

Price History

DatePrice
Visit shop