MOTIP CLEAR COAT LACQUER SPRAY PAINT 500ML - Matt Finish

The lacquer is touch-dry within minutes and can be recoated after 5-10 minutes, depending on ambient temperature and humidity.

While it can be used on automotive parts like trim or wheels (non-contact areas), it is not intended as a primary automotive paint. Always test adhesion first.

After use, turn the can upside down and spray for a few seconds to clear the nozzle. Store in a cool, dry, well-ventilated area away from heat and direct sunlight.

It is recommended to apply multiple thin, even coats rather than one heavy coat for the best finish and durability. Allow 5-10 minutes between coats.

Yes, the lacquer is resistant to weather influences and is UV resistant, making it suitable for outdoor applications on appropriate surfaces.

Yes, this clear coat can be painted over once fully cured, provided the surface is prepared appropriately for the subsequent paint layer.

Ensure the nozzle is not clogged. Turn the can upside down and spray briefly to clear. Shake the can more vigorously and frequently during use. Ensure the can is at an appropriate temperature (room temperature is best).

Verify the surface was thoroughly cleaned, degreased, and dry before application. Ensure any necessary primer was used. Lightly sand the surface if it was previously treated and glossy.

You are likely applying the paint too thickly or from too close a distance. Apply in multiple thin, even coats, allowing adequate drying time between each. Maintain a consistent spraying distance of 25-30 cm.

This can occur if the surface was not properly prepared or if coats were applied unevenly. Ensure consistent application technique and adequate surface preparation.