Evo-Stik Instant Grab Wall Tile Adhesive - White

This adhesive is suitable for most internal surfaces, including plaster, plasterboard, glazed tiles, brick, cement, cement renders, and tile backer boards.

No, this adhesive is specifically designed for ceramic wall tiles and is not suitable for floors.

While it is showerproof, it is not fully waterproof. It's suitable for areas subject to some splashing and condensation, but not for areas with constant water exposure.

Drying times can vary, so always refer to the manufacturer's instructions on the packaging for specific guidance. Allow sufficient time before grouting.

A 10L bucket can fix up to 11m² depending on the substrate and tile size.

Priming is not always necessary, but it is recommended for porous surfaces. Always check the manufacturer's instructions.

Yes, you can tile directly onto most existing tiles, provided the surface is clean, sound, and properly prepared.

Ensure the surface is properly prepared, clean, and free from contaminants. Check the expiry date of the adhesive. Apply the adhesive correctly and press the tiles firmly into place.

Work in manageable sections. Avoid applying the adhesive in direct sunlight or high temperatures. Ensure proper ventilation.

Use the correct size notched trowel for the tile size. Make sure the adhesive is not too thick. If necessary, lightly thin with water, following the manufacturer's instructions.

Ensure the surface is level. Apply the correct amount of adhesive and press the tiles firmly into place. Use tile spacers to maintain even spacing.