Best current price£46.49from B&Q
Shopping.co.uk recommended and popular offers
B&Q£46.49Visit shop - Automatic Up & Down Ip44 Wall Light With Pir2 X 7W Gu10 LedBrushed Steel
Visit shop3 offers from £46.49 - £47.49
View price history by clicking the chart icon.
This Loops Automatic Up & Down IP44 Wall Light in Silver is ideal for homeowners seeking an attractive, affordable exterior lighting solution with motion detection. Its primary benefit is enhanced security and convenience through automatic illumination. A potential caveat is that it requires separate bulb purchases. This fitting offers a designer aesthetic with a built-in PIR sensor, adjustable timer, and durable stainless steel construction, suitable for various outdoor environments.
| Colour | Silver |
|---|---|
| Model Part Number | x00638 |
| Brand | Loops |
This light requires two 7W LED GU10 bulbs. These are not included with the fitting.
Yes, the PIR sensor has an adjustable timer (5 sec - 5 min) and adjustable lux sensitivity (10-2000 lux).
Yes, this fitting features a manual override function that allows you to control the light independently of the PIR sensor.
The light is IP44 rated, which protects against water splashes. For very harsh coastal environments, additional protection or a higher IP rating might be preferable.
The light is constructed from 304 brushed stainless steel and clear glass.
The dimensions are 108mm Projection, 210mm Height, and 70mm Width.
Please refer to the retailer's warranty policy for specific details regarding the warranty period and coverage.
Check that the power supply is connected and the circuit breaker is active. Ensure the correct bulbs are installed and functioning. Verify that the PIR sensor is enabled and not overridden.
Confirm the detection angle and range are unobstructed. Clean the PIR sensor lens. Adjust the lux sensitivity setting to ensure it's not set too high for daylight conditions. Check the timer setting.
Check if the manual override function has been activated. If not, the PIR sensor may be faulty or the ambient light setting (lux) may be too low, causing it to continuously detect motion.
Adjust the timer function to the desired duration (5 seconds to 5 minutes).
Setup: This fitting is Class 1 and requires connection to a 220-240V power supply. Installation should be performed by a qualified electrician. Ensure the power is switched off at the mains before commencing any wiring. Mount the light securely to the wall, ensuring adequate clearance as per the dimensions (108mm Projection x 210mm Height x 70mm Width). Connect the wiring according to local electrical codes. Insert two 7W LED GU10 bulbs (not included). Once installed, configure the timer and lux settings on the PIR sensor as desired.
Compatibility: The light requires two 7W LED GU10 bulbs. It operates on a standard 220-240V power supply. The manual override PIR sensor is compatible with standard electrical circuits.
Care: To maintain its appearance and function, regularly clean the exterior with a soft, damp cloth. Avoid using abrasive cleaners or solvents, which can damage the stainless steel finish and glass. Ensure the PIR sensor lens remains clean for optimal performance. Periodically check for any obstructions around the sensor.
