Blomberg Heat Pump Tumble Dryer - Grey A++ LTA18321G

Open the door and remove the lint filter. Pull the filter open and remove any lint. Rinse under warm water to remove any remaining lint. Allow to dry completely before replacing.

The water tank is located at the top of the dryer. It collects water condensed during the drying cycle.

The condenser should be cleaned periodically, ideally every three months. Refer to the user manual for detailed instructions.

No, this model cannot be installed under a worktop.

The delay start function allows you to set the dryer to start at a later time, up to 24 hours in advance.

The Blomberg LTA18321G comes with a free 5-year warranty (via registration).

The anti-crease function automatically tumbles the clothes after the drying cycle to prevent wrinkles. It can be activated by selecting the appropriate program or setting.

Consult the user manual for the specific error code and its corresponding troubleshooting steps. If the problem persists, contact Blomberg customer support.

Check the power supply and ensure the dryer is plugged in correctly. Check the fuse or circuit breaker.

Check if the lint filter is clean and if the water tank is full (if applicable). Ensure the correct drying program is selected.

Ensure the load is not overloaded. Clean the lint filter and check for any blockages in the ventilation system.

Refer to the user manual for specific error code meanings and solutions.

Check for trapped items such as buttons or coins. Ensure the dryer is level.