Detectable Underground Tape - Rising Main - 150mm - Pegdev

The primary purpose is to provide a clear, visible, and detectable warning for buried services such as rising mains, pipes, and cables, preventing accidental damage during excavation.

The tape contains two stainless steel wires. These wires are detectable using standard metal detection equipment, allowing excavators to locate the tape and, by extension, the buried service before digging.

The '150mm' refers to the width of the Detectable Underground Tape.

This tape complies with EN 12613 standards, ensuring it meets specified safety and performance requirements.

While designed for services like rising mains, pipes, and cables, its primary function is to warn of buried utilities. It's most effective when placed directly above or in close proximity to the service being protected.

The tape is made from polypropylene and is resistant to rot and other environmental factors, designed for underground conditions. The stainless steel wires offer good corrosion resistance.

While designed for durability and resistance to environmental factors, the longevity can depend on specific soil conditions and ground movement. It is intended for long-term marking of services.

Ensure the locator is functioning correctly and set to detect metallic traces. Verify that the tape was installed with the stainless steel wires facing upwards or in a position accessible by the locator antenna. Check for any significant damage to the tape that may have broken the wires.

If the tape shows signs of damage (e.g., tears, breaks), carefully inspect the area around the damage. If the service is confirmed to be intact, consider installing a secondary layer of tape or using alternative marking methods. Report the damage to the site supervisor.

Use guide stakes or temporary markers to maintain the desired path of the tape during installation, especially in long runs or complex trench layouts.