Setup, Compatibility & Care
- Preparation: Ensure your rafters are at least 50mm wide and in good condition. Measure and cut the glazing material to the correct size.
- Gasket Installation: Attach the 50mm gasket to the rafter using galvanised nails (not included), spaced every 300mm along the length of the bar.
- Bar Installation: Position the screw-down aluminum bar and secure it with screws every 300-350mm.
- End Plate Installation: Attach the push-fit end plates. If using glass, replace with aluminum mechanical end plates (sold separately).
- Finishing: Use plastic screw covers for a clean finish.
Compatibility: Compatible with multiwall and solid polycarbonate, and glass. Ensure rafter dimensions meet the minimum width requirement.
Care: Regularly inspect the system for any signs of damage or wear. Clean with mild soap and water. Ensure that the drainage holes are not blocked. Replace any damaged components promptly.