Fascia Board Internal Corner - 300mm

No, this product is specifically designed for internal corners where two fascia boards meet in a valley.

Use a professional-grade PVC adhesive or solvent weld for the fixed side of the joint.

PVC plastic expands and contracts significantly with temperature changes. Without the gap, the boards will buckle or pop out of alignment.

Yes, a standard hacksaw or a fine-toothed handsaw will cut through the PVC cleanly.

Minimal maintenance is required; cleaning it with soapy water during regular gutter cleaning is sufficient.

This occurs if both sides were glued down. Ensure one side remains loose with only silicone applied to allow for thermal movement.

Ensure the fascia boards are plumb and square; if the gap persists, check that the trim was cut square to the fascia profile.