Setup, Compatibility & Care
Setup:
Installation requires Polypipe Solvent Weld ABS Cement and Primer (sold separately). Ensure the ends of the pipe and the inside of the fitting are clean and free from dust. Apply primer to both surfaces, followed by a generous coat of ABS cement to both surfaces. Immediately push the pipe fully into the fitting with a slight twisting motion and hold for 30 seconds to prevent 'bell push-out'. Wipe away excess cement. Allow adequate time for the joint to set before testing or stressing the system. Refer to the solvent weld cement manufacturer's instructions for specific setting and curing times.
Compatibility:
This 50mm ABS pipe is part of the Polypipe Waste Systems range and is designed to connect with other Polypipe Solvent Weld ABS fittings and accessories. It is compatible with standard Polypipe traps and overflow solutions. While it is generally suitable for all domestic waste water, always ensure compatibility with any non-Polypipe components used in your installation.
Care:
Clean the exterior of the pipe with a damp cloth if necessary. Avoid using harsh solvents or abrasive cleaners, which could damage the finish or material. Ensure the system is flushed regularly to prevent blockages within the pipework.