Trend No. 6 Snappy Countersink - SNAP/CS/6

This countersink is designed for No.6 screws.

Use a 2.4mm (3/32in) drill bit for pilot holes.

Yes, it is compatible with power screwdrivers that accept a 1/4in hex shank.

Drill a pilot hole first, then use the countersink to create a 9.5mm (3/8 inch) diameter counterbored hole.

Clean the bits after each use to remove wood shavings and debris. Store in a dry place. Check the bits regularly for wear.

The hex shank provides a secure and efficient power transfer from the drill to the countersink.

Replacement bits are available from Trend stockists.

Ensure you are using the correct drill bit size (2.4mm). Check for any damage or wear on the countersink bit. Adjust the drill speed.

Apply consistent pressure and maintain a straight drilling angle. Make sure the wood is securely clamped.

Ensure the countersink is creating a deep enough recess. Adjust the drilling depth if necessary.