Cleenly Pool Algae Remover for Hot Tub & Spa - 2 x 1L

For best results, use it as a weekly treatment. You can also use it to treat existing algae blooms as needed.

The general guideline is 10ml of Cleenly Algae Remover per 1000 liters of water. Always refer to the product label for specific instructions based on your pool size and the severity of the algae problem.

Yes, Cleenly Algae Remover is safe for use in hot tubs and spas, as well as all types of swimming pools.

Typically, you will notice a significant reduction in algae within 24-48 hours of application, though results can vary based on the extent of the algae growth and water conditions.

It is recommended to ensure your pool's pH is balanced before application for maximum effectiveness. If you have a very heavy algae bloom, you may need to shock the pool with chlorine first.

This algae remover is designed to work with standard pool sanitizers. However, it's always good practice to test and balance all water parameters after treatment.

If you believe you've added too much, increase your pool's filtration and circulation. You may also need to dilute the water by partially draining and refilling the pool, and re-testing chemical levels.

Ensure your pool's pH is within the recommended range (7.2-7.6) and that your circulation system is running adequately. Re-test water chemistry and consider a higher dose if the infestation is severe, following product guidelines.

Cloudiness can sometimes occur as algae dies off. Ensure your pool filter is clean and running. Brush the pool walls and floor to help collect dead algae, and run the filter continuously until the water clears.

Verify the correct dosage has been used based on your pool's volume. Check that the water temperature is suitable for treatment and that other pool chemicals are balanced, particularly chlorine levels.