Best current price£30.00from Homebase
Shopping.co.uk recommended and popular offers
Homebase£30.00Visit shop D-C-Fix Sonoma Oak Light Sticky Back Plastic Vinyl Wrap Film 90Cm X 5M
Visit shop3 offers from £30.00 - £36.00
View price history by clicking the chart icon.
The D-C-Fix Sonoma Oak Light Sticky Back Vinyl Film is an ideal solution for DIY enthusiasts and renters looking to refresh furniture, worktops, or kitchen doors without the expense of a full renovation. This high-quality, German-engineered film offers a realistic oak wood grain aesthetic that is both durable and easy to maintain; however, users should be mindful that it requires protective mats for hot kitchenware and is not intended for direct high-heat contact above 70°C.
| Brand | D-C-Fix |
|---|
Yes, but you must apply a bead of silicone sealant around all edges and where the worktop meets the wall to prevent water from getting under the film.
It is heat-resistant up to 70°C. You must use heat-resistant mats for hot pots and pans.
Yes, it is designed for removal. Applying heat from a hairdryer during the removal process can help soften the adhesive and make it easier to peel off.
The film performs best on smooth, non-porous surfaces. It may not adhere well to rough, deeply textured, or dusty surfaces.
Measure your surface area in square meters and add 10-15% for trimming and pattern matching. Each roll covers 4.5 square meters.
Use a small, sharp needle to prick the center of the bubble, then gently press the air out toward the hole with a squeegee.
Ensure the surface was fully degreased before application. If it continues to lift, use a hairdryer to lightly warm the adhesive and press firmly into place.
Apply gentle heat with a hairdryer to increase the material's flexibility, allowing it to stretch and fold around edges more effectively.
To install, start by measuring your target surface and cutting the film with an extra 2-3cm allowance on all sides. Peel back a portion of the backing paper and press firmly onto the clean, dry surface. Use a felt-edge squeegee to push out air bubbles as you work across the piece. For edges, use a hairdryer on a low heat setting to make the film pliable, allowing it to wrap snugly around corners or tight curves. For long-term care, avoid using abrasive sponges or harsh chemical cleaners. A simple wipe with a soft, damp cloth and mild soap is sufficient to keep the surface looking new. Ensure all cut edges in moisture-prone areas are sealed with clear silicone sealant.
