Dylon Hand Dye - Smoke Grey

This dye is specifically formulated for natural fabrics such as cotton, linen, viscose, wool, and silk. It will not work on pure synthetic materials like polyester, nylon, acrylic, or fabrics with special finishes.

Yes, you will need 250g of ordinary salt (e.g., table salt or cooking salt) for each 50g pack of Dylon Hand Dye. This salt helps the dye absorb properly into the fabric.

No, Dylon Hand Dye is designed for hand application only. For machine dyeing, you would need a different Dylon product specifically formulated for washing machines.

One 50g pack is designed to dye up to 250g of fabric (which is approximately one shirt or a large t-shirt) to a full, rich shade. If your fabric is heavier, the resulting color will be lighter, or you'll need to use more dye packs.

When dyeing an already colored fabric, the original color will combine with the new dye color. For instance, dyeing a light yellow fabric with Smoke Grey might result in a brownish-grey or muted green-grey. For best results and true-to-pack color, start with white or very light-colored fabric.

To achieve an even result, ensure the fabric is completely clean and damp before dyeing. Submerge the fabric fully and stir continuously for the first 20 minutes, then regularly for the remainder of the dyeing time (at least 45 minutes). Make sure the salt is fully dissolved and the water temperature is consistent.

Ensure the fabric weight does not exceed 250g per pack of dye. Use the correct amount of salt (250g). Maintain consistent water temperature and stir the fabric continuously, especially during the first 20 minutes, to ensure even dye absorption. Ensure the fabric was clean and free of finishes before dyeing.

Verify the fabric composition. This dye works only on natural fibers (cotton, linen, viscose, wool, silk). It will not color pure synthetics like polyester, nylon, or acrylic, or fabrics with special finishes. Pre-wash the fabric thoroughly to remove any sizing or treatments.

Always wear rubber gloves when handling dye. Protect work surfaces with old newspapers or plastic sheets. Clean any spills immediately with warm, soapy water. Rinse the basin thoroughly with hot water and detergent immediately after use to prevent staining.

This is normal for the first few washes. Rinse the fabric very thoroughly after dyeing until the water runs clear. For the first few washes, wash the dyed item separately in cold water. You can also use a 'dye fixative' product (sold separately) after dyeing to help set the color.