Ecotile Interlocking Floor Tiles - Red Rubber

No, the Ecotile Interlocking Floor Tiles are designed to be laid without adhesives. They simply tap into place with a rubber mallet.

They can be installed over most existing solid surfaces, including concrete, asphalt, and wooden floors. The subfloor should be reasonably clean and dry.

Yes, the 7mm thick tiles are designed to withstand the weight of typical passenger vehicles. For heavier vehicles, consult the manufacturer.

You can clean the tiles with a damp mop and a mild detergent. Avoid harsh chemicals or abrasive cleaners.

The PVC material is water-resistant, and the interlocking design helps to prevent liquids from seeping through to the subfloor. They effectively eliminate damp from concrete floors.

Yes, one of the key benefits of Ecotile is that they can be easily lifted, moved, and reinstalled in a new location.

The tiles have an R10 slip resistance rating, providing good grip underfoot, even in potentially wet conditions.

Yes, the tiles are made with 50% recyclable material.

Ensure the interlocking edges are clean and free from debris. Make sure you are using a rubber mallet and striking firmly but squarely on the joining edges.

Check that the interlocking mechanism is fully engaged. Gently tap along the edges with the rubber mallet to ensure a tight fit. Ensure the subfloor is relatively level.

This is usually due to an uneven subfloor. For a flatter finish, ensure the underlying surface is as smooth as possible before installation. Minor unevenness can be managed with careful tapping.

Avoid forcing tiles together. If a joint appears damaged, inspect the tile and replace if necessary. Ensure the rubber mallet is used correctly to avoid excessive force.