FloPlast Round Downpipe Shoe - Brown - 68mm

The primary function is to direct rainwater away from the building, preventing water damage to the foundations and surrounding areas.

Installation is simple; it uses a push-fit joint. Just push the shoe onto the end of the 68mm downpipe.

Sealant is not required for installation, but it is recommended for added security, especially in areas with pedestrian traffic. You can use silicone sealant or solvent weld.

This shoe is designed to fit 68mm round downpipes.

You can clean the shoe by detaching it (if not sealed) and rinsing it with water. For sealed shoes, clean in place using a brush or similar tool.

The downpipe shoe is made of durable plastic.

The shoe is designed for easy removal for cleaning, thanks to the push-fit joint. However, if you use sealant, removal will be more difficult.

Ensure the downpipe is properly cut and the shoe is fully engaged. If this persists, apply silicone sealant or solvent weld to secure the connection.

Check the fit of the shoe onto the downpipe. Ensure there are no obstructions and that the connection is secure. Re-fit and use sealant if necessary.

Detach the shoe (if not sealed) and remove any debris. Rinse with water. For sealed shoes, use a brush or similar tool to remove the blockage.