Best current price£17.07from eBay
Shopping.co.uk recommended and popular offers
eBay£17.07Visit shop Workshop Warehouse WHIP HOSE 06M LONG 7MMX14MM AL60
Visit shop
B&Q£22.81Visit shop B&Q - Whip Hose 0.6M Long7mm 1/4" Male Al60 Qty 1
Visit shop5 offers from £17.07 - £24.92
View price history by clicking the chart icon.
The Van Line Air Tool Whip Hose (AL60) is an essential safety accessory for professionals and hobbyists working with pneumatic systems in automotive, engineering, or agricultural settings. Designed to prevent dangerous hose whipping during accidental disconnection, it acts as a flexible buffer between your rigid air line and the handheld tool. While it provides critical safety and vibration dampening, users should note its fixed 0.6-meter length, which may necessitate additional standard hoses for extended reach requirements.
| Model Part Number | AL60 |
|---|---|
| Brand | Van Line |
A whip hose protects the operator by preventing a pressurized air line from thrashing (whipping) around if the tool connection fails.
It is compatible with most standard pneumatic tools that accept 1/4 inch BSP fittings.
It is not recommended, as each connection point adds a potential failure risk and reduces overall system efficiency.
It means the hose meets the International Organization for Standardization requirements for pneumatic fluid power system safety.
Replacement intervals depend on usage, but you should replace it immediately if you observe any cracks, bulges, or excessive wear on the outer casing.
Ensure thread sealant tape was applied correctly and verify that the BSP fittings are fully tightened.
Check for internal kinks in the hose or verify that the air supply pressure at the compressor is adequate for the tool being used.
Installation is straightforward: screw the BSP male tailpiece into your air tool, and attach your main airline to the adaptor end of the whip hose. Before operation, ensure all thread connections are tightened to prevent leaks, though the use of thread sealant is recommended for air-tight seals. To maintain the hose, regularly inspect the outer casing for abrasions, cracks, or signs of dry rot. Avoid dragging the hose over sharp metal edges or hot engine components, as extreme heat can compromise the integrity of the material over time. When not in use, store the hose in a clean, dry area away from direct sunlight.
