Fujifilm Instax Mini Film - Sprinkles

The actual image area where your photo appears is 46x62mm. The total film sheet size, including the 'Sprinkles' border, is 54x86mm.

Instax Mini photos typically begin to develop immediately after ejection and are fully visible within 90 seconds, though full color development can take up to 5 minutes, especially in cooler temperatures.

No, this film is exclusively designed for Fujifilm Instax Mini cameras and Mini Smartphone Printers. It is not compatible with Instax Wide or Instax Square formats due to different film and camera sizes.

Store unopened film packs in a cool, dry place, away from direct sunlight, high humidity, and extreme temperatures. An indoor room temperature environment is ideal. Avoid storing it in places like a car glove box or direct window sill.

A color cast can sometimes indicate that the film is old or has been exposed to extreme temperatures or light before or during development. Ensure you are using film within its expiration date and storing it properly. Also, try to keep the ejected photo out of direct sunlight as it develops.

The 'Sprinkles' border design is fixed and uniform across all 10 prints within a single pack. The design does not change per shot, providing a consistent decorative theme for your photos.

Check your camera's light settings. If photos are white, it may be overexposed (too much light). If black, it may be underexposed (too little light). Ensure the flash is enabled in dark environments or disabled if taking photos in bright, direct sunlight. Avoid blocking the flash or the light sensor.

Ensure the film pack is inserted correctly and fully. Open the film compartment, gently remove the film pack, and reinsert it, aligning the yellow marks precisely. Check the battery level of your camera/printer; low batteries can sometimes prevent film ejection.

Ensure you are holding the camera steady when taking a picture. Check the recommended shooting distance for your specific Instax Mini camera model; some models have a minimum focus distance. Also, clean the camera lens if it appears smudged or dirty.

This often indicates that the film pack may be empty or not properly seated. Verify the film counter on your camera/printer. If the counter shows 0, the pack is empty. If not, try reinserting the film pack as described above.