Theben Motion Switch - theLuxa S150 WH

The optimal mounting height for this motion switch is 2.5 meters. However, it can be installed between 2 and 4 meters.

Yes, the theLuxa S150 WH features mixed light measurement and is suitable for controlling LED lamps, as well as fluorescent, incandescent, and halogen lamps.

The maximum frontal range is 12 meters, and the maximum sideways range is 6 meters. The detection angle is 150° horizontally.

Yes, it has an IP55 rating, which means it is protected against dust ingress and low-pressure water jets, making it suitable for outdoor placement.

The response value for luminosity can be adjusted between 5 lx and 1000 lx using the dedicated control on the device. A teach-in function is also available to set the current brightness value.

The maximum switching power is 2300W, with a maximum starting current of 10A.

Yes, the sensor head can be rotated ±90° horizontally and tilted downwards by 30°, allowing for precise aiming of the detection area.

Check the power supply and wiring connections. Ensure the ambient light setting is low enough for the sensor to trigger. Verify that the switch-off delay has not been set to the minimum time. Test the detection area using the test function.

Ensure there are no constant sources of heat or movement within the detection range that could be triggering the sensor. Check the switch-off delay setting; it might be set too high. Verify that the sensor is not obstructed.

Clean the sensor lens. Ensure the device is mounted at the optimal height (around 2.5 meters). Re-adjust the sensor head's horizontal and vertical angles to cover the desired area. Check for any environmental factors (e.g., direct sunlight, heat sources) that might interfere with the PIR sensor.

Verify that the AC power source is connected correctly and providing 230V. Check the circuit breaker or fuse for the connected power line. Ensure all wiring connections are secure.