OMP Replacement Visor - Clear

This clear replacement visor is compatible with OMP Circuit Helmet models manufactured between 2017 and 2019.

No, this visor is specifically NOT suitable for the later Circuit Evo model (2020 onwards).

Typically, you'll remove the old visor by undoing the mechanism on each side, then align and click the new visor into place. Refer to your helmet's manual for detailed instructions.

As a clear visor, it is designed for general use and good visibility in daylight or well-lit conditions. For specific low-light or night conditions, tinted or specialized visors might be more appropriate, but this clear version offers maximum light transmission.

This product listing is for a standard clear replacement visor. It does not include specific anti-fog coatings unless explicitly stated. You may need to use separate anti-fog treatments if fogging is an issue.

Inspect the visor upon arrival. If it is scratched, do not install it. Contact the seller or manufacturer immediately to arrange for a replacement.

Visors should be replaced if they are cracked, significantly scratched, or if optical clarity is compromised. Regular inspection is recommended, especially after any impact or if visibility is reduced.

Ensure you have the correct visor model for your helmet year range (2017-2019 Circuit). Check that the helmet's pivot mechanisms are clean and free of debris. Realign the visor carefully with the pivot points.

Verify that the visor is fully seated on both pivot points. Some helmets have small adjustment screws near the pivots; ensure these are properly tightened if applicable to your helmet model.

This visor is designed for optical clarity. Ensure no protective film remains on the visor. If the issue persists, the visor may be defective or incompatible.