Q.Max Sheet Metal Punch - 25mm

This punch is designed for sheet metal up to 16 gauge (approximately 1.5mm).

Yes, you will need to purchase the corresponding hexagonal key (8mm for the 25mm punch) and the die separately.

The cutting edges are heat-treated for durability, but like all cutting tools, they may eventually require sharpening or replacement after significant use.

The special design of the punch is intended to create burr-free holes. Ensure the tool is properly set up and the metal is within the specified thickness limit for best results.

It means that the punch tool itself is sold as a single unit, but the essential accessory, the hexagonal key required to operate it, is not included and must be ordered separately.

This tool is specifically designed for cutting clean holes in sheet metal up to 16 gauge. It is not intended for use on thicker materials, plastic, or wood.

After use, clean the punch and store it in a dry place. A light application of oil on the metal parts can also help prevent rust due to its anti-corrosive surface finish.

Ensure the sheet metal is within the 16-gauge limit. Check for damage to the cutting edges of the punch and die. Lubricate the screw threads.

Verify that the die nut is properly seated against the metal. Ensure the punch and screw threads are clean and lightly lubricated. Confirm you are using the correct size hexagonal key.

This can occur if the metal is too thick or if the cutting edges are dull. Try backing the screw out slightly and re-engaging to complete the cut. For recurring issues, the punch may need sharpening or replacement.

Make sure the punch is correctly threaded onto the screw and that the die is properly positioned. Ensure the screw tip is centered on the intended punch location.