Animal Print Cutter - Multicolor

This cutter works best with firm modelling paste, sugar paste, or fondant rolled to approximately 2-3mm thickness.

Use firm, even pressure when pressing down and sliding the cutter. A light dusting of cornflour on your work surface and paste can prevent sticking. Ensure the paste is rolled to the correct thickness.

While designed for food use, it could be used with soft clays or playdough. However, ensure it is thoroughly cleaned if it will be used with food afterward.

The approximate finished size of the cutouts is 80mm x 190mm.

You can attach the cutouts using a small amount of edible glue or a tiny bit of water applied with a fine brush.

No, it is recommended to hand wash the cutter in warm, soapy water and allow it to air dry completely.

Yes, you can focus on using the sections that create your desired print (zebra, leopard, or giraffe) by carefully positioning and pressing the cutter.

Ensure the work surface and paste are lightly dusted with cornflour (or powdered sugar for darker pastes) before cutting. Ensure the paste is rolled to the correct thickness (approx. 2-3mm).

Apply firm, even pressure when pressing down. Ensure the cutter slides back and forth gently to create a clean separation. Rolling the paste slightly thicker may also help.

Ensure the modelling paste is smooth and has been kneaded sufficiently. Check that the cutter is being pressed directly down onto the paste without tilting.

Soak briefly in warm water if paste is dried on. Use a soft brush to gently dislodge any residue. Always ensure the cutter is completely dry before storing.