Best current price£10.38from PCHUB.UK
Shopping.co.uk recommended and popular offers
PCHUB.UK£10.38Visit shop Startech.com Gray 5M Slim Cat6 Ethernet Cable. Snagless. 100W Poe. Utp
Visit shop6 offers from £10.38 - £13.95
View price history by clicking the chart icon.
This 5-meter gray Slim Cat6 Ethernet cable from StarTech.com is designed for high-density installations where space is limited. It offers reliable Gigabit Ethernet and 100W PoE++ connectivity with improved airflow and flexibility compared to standard cables. A key benefit is its LSZH jacket for safer installation in various environments. However, its specialized slim design might limit compatibility with certain older or ruggedized cable management systems.
| Series | Cat6 |
|---|---|
| Model Part Number | N6PAT5MGRS |
| Brand | StarTech.com |
The primary advantage is its significantly smaller diameter (36% thinner), which allows for much better airflow in high-density installations and makes it easier to route in confined spaces like crowded network racks.
Yes, this cable fully supports PoE++ (up to 100W) in compliance with IEEE 802.3bt Type 4 specifications. It can power high-demand PoE devices.
LSZH stands for Low Smoke Zero Halogen. This means the cable jacket is designed to emit very little smoke and no toxic halogens when exposed to high heat or fire, making it safer for use in poorly ventilated areas.
This is a Cat6 cable, which is rated for up to 1000 Mbps (Gigabit Ethernet) at distances up to 100 meters. For 10 Gigabit Ethernet, you would typically need a Cat6a or Cat7 cable.
The snagless boot protects the RJ45 clip during installation, reducing the risk of it breaking or snagging on other cables or surfaces. While more robust than standard connectors, they can still be damaged with excessive force.
The cable uses 28AWG pure bare copper wire. This provides excellent conductivity for reliable data transmission and power delivery.
While not explicitly stated, for Cat6 cables, a general guideline for the minimum bend radius is approximately four times the cable's outer diameter. For this slim cable (~3.6mm), avoid bending it tighter than roughly 14.4mm (about half an inch) to prevent damage.
Ensure both RJ45 connectors are fully seated and clicked into their ports. Verify the cable is not physically damaged, kinked, or severely bent. Test with a different known-good Ethernet cable to isolate the issue. Check network device settings and port status.
Confirm that the connected network device and the power sourcing equipment (e.g., PoE switch) support PoE++ and the required wattage (up to 100W). Ensure the cable is fully connected to both the power source and the device. Verify the PoE settings on the switch are enabled for the specific port.
Ensure the cable is properly terminated and undamaged. Check that both the cable and connected devices support Gigabit Ethernet speeds. Verify network switch configuration and traffic load. Test the connection with a shorter or different Cat6 cable to rule out cable degradation.
While the snagless boot offers protection, forceful insertion or removal can still damage clips. If the clip is broken, the cable may not stay securely in the port. Consider replacing the cable to ensure reliable connection. For temporary solutions, tape might secure it, but this is not recommended for long-term use.
Setup: Simply plug the RJ45 connectors into your network devices, such as switches, routers, computers, or PoE-powered devices. Ensure a firm click to confirm the connection. The snagless boot design aids in routing the cable through tight spaces without damaging the connector clip.
Compatibility: This cable is compatible with all 10/100/1000Base-T Ethernet devices. It fully supports IEEE 802.3bt Type 4 PoE++ (up to 100W), making it suitable for powering high-demand PoE devices. It adheres to Cat6 standards, ensuring compatibility with network equipment designed for Cat5e, Cat6, and Cat6a.
Care:
