Best current price£59.99from B&Q
Shopping.co.uk recommended and popular offers
B&Q£59.99Visit shop - 24V Dc 150W Constant Led Driver / Transformer Low Voltage Light Power Converter
Visit shop3 offers from £59.99 - £67.49
View price history by clicking the chart icon.
This Loops 24V DC 150W Constant LED Driver is designed for users needing a reliable power source for low-voltage LED lighting systems, offering stable performance for indoor applications. Its key benefit is consistent power delivery for a wide range of LED setups. A caveat is its IP20 rating, making it unsuitable for wet or outdoor environments.
| Model Part Number | x00107 |
|---|---|
| Brand | Loops |
The IP rating is IP20, which means it offers no protection against liquids and is suitable for dry, indoor environments only.
No, due to its IP20 rating, this driver must not be used outdoors or in wet environments.
No, this is a non-dimmable LED driver.
The driver has a maximum power rating of 150 watts.
It is compatible with 24V DC constant voltage LED products, such as LED strips and modules.
The dimensions are 34mm in height, 67mm in width, and 210mm in length.
Yes, it comes complete with fixing accessories for installation.
Check that the power supply is connected and the mains switch is on. Verify all wiring connections are secure and correct at both the input and output terminals. Ensure the total wattage of the connected LEDs does not exceed the driver's 150W capacity.
This could indicate an unstable power supply or an overloaded driver. Ensure the connected LED load is within the 150W limit and that the driver is functioning correctly. Check for loose connections.
Some warmth is normal during operation, especially under full load. However, if the driver is excessively hot, check that ventilation is adequate and that the connected LED load does not exceed the 150W rating. Ensure it is installed in a suitable, non-enclosed space.
A faint hum can sometimes occur with transformers. If the noise is loud or persistent, check for secure mounting and ensure the driver is not vibrating against any surfaces. If the hum is significant, it may indicate a fault, and the unit should be inspected or replaced.
Setup: Ensure the power source is disconnected before installation. Connect the input wires from your mains power supply to the appropriate terminals on the driver. Then, connect your 24V DC LED lights to the output terminals. Secure the driver using the provided fixing accessories. For safety, all wiring should be performed by a qualified electrician.
Compatibility: This driver is designed for 24V DC constant voltage LED products only. Verify that the total wattage of your LED setup does not exceed the driver's 150W limit. It is compatible with LED strips, modules, and fixtures specifically rated for 24V DC constant voltage.
Care: Keep the driver in a dry, well-ventilated area. Avoid exposing it to moisture or dust. Clean the exterior with a dry or slightly damp cloth. Ensure ventilation slots are not obstructed. Due to its IP20 rating, it must be installed in areas free from water and excessive humidity, such as kitchens (excluding zones near water sources) and general living areas.
