Best current price£0.52from Power Tools Direct
Shopping.co.uk recommended and popular offers
Power Tools Direct£0.52Visit shop Draper 59466 Aluminium Oxide Sanding Sheets 232 X 92Mm 100 Grit (Pack Of 10) Per Pack
Visit shop
B&Q£4.37Visit shop B&Q - Aluminium Oxide Sanding Sheets232 X 92mm100 Grit (Pack Of 10) 59466
Visit shop13 offers from £0.52 - £19.99
View price history by clicking the chart icon.
This guide is for DIY enthusiasts and professionals using 1/3 sheet sanders. The Draper Aluminium Oxide Sanding Sheets offer a reliable way to achieve smooth finishes on wood, metal, plastic, and plasterboard with their 100 grit abrasive. A key benefit is their consistent performance for general-purpose sanding tasks. However, users should note that this specific pack is optimized for 100 grit, and other grit levels may be needed for very coarse or very fine finishing.
| Model Part Number | 59466 |
|---|---|
| Brand | Draper |
Grit refers to the coarseness of the abrasive. A lower grit number (like 100) indicates a coarser abrasive, suitable for faster material removal and rougher sanding. Higher grit numbers are finer.
The 100 grit is generally considered medium. For very fine finishing, especially before applying paint or a clear coat, you would typically move to higher grit papers (e.g., 180, 220, or higher).
A 1/3 sheet sander typically has a rectangular base plate designed to accept a sheet of sandpaper cut into three equal parts. The dimensions 232 x 92mm are standard for this type.
This pack contains 10 sheets of sanding paper.
Sanding sheets are consumable. While you can tap them to remove dust, they will eventually wear down and lose their abrasive effectiveness and should be replaced when performance diminishes.
These sheets are suitable for use on wood, metal, plastic, and plasterboard.
Aluminium oxide is a very common, durable, and sharp abrasive material widely used in sandpaper due to its ability to cut through materials efficiently and its long lifespan.
Ensure the sander's clamping mechanism is fully engaged and that the sheet is taut and free of wrinkles. Check if the sander's base plate is clean and undamaged.
Verify the sanding sheet is correctly and evenly attached to the sander. Apply consistent, moderate pressure and avoid dwelling too long on one spot. Ensure the sander's pad is not damaged.
This can occur when sanding soft materials like certain woods or painted surfaces. Try to maintain good dust extraction and consider a coarser grit if available for initial removal, or a finer grit for finishing. Clean debris from the sheet by tapping it gently.
Check that the sanding sheet is new and not worn out. Ensure you are applying adequate, consistent pressure. For tougher materials, a coarser grit may be necessary, or the material might require pre-treatment.
Setup: To set up, ensure your 1/3 sheet sander is switched off and unplugged. Carefully remove any old sanding sheet. Place the new Draper Aluminium Oxide Sanding Sheet onto the sander's base plate, aligning the pre-punched holes with any dust extraction ports. Secure the sheet using the sander's clamping mechanism, ensuring it is taut and wrinkle-free.
Compatibility: These sheets are specifically designed for most standard 1/3 sheet orbital sanders. Always check your sander's manual to confirm the required sheet size and type.
Care: Sanding sheets are consumable items and are not designed for long-term storage or reuse once the abrasive is worn. To maintain performance, periodically tap the sheet to dislodge dust and debris. If the sheet becomes clogged or worn, it should be replaced. Store unused sheets in a dry environment to prevent degradation of the adhesive and abrasive.
