Prima Classic Compression Reducer - 15 X 10mm
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Prima Classic Compression Reducer is designed for plumbers and DIY enthusiasts needing to connect pipes of different sizes in water or gas installations. Its key benefit is providing a reliable, secure, and WRAS-approved connection for drinking water systems at great value. A caveat to consider is its specific application as a reducer, meaning it's for transition between 15mm and 10mm pipes only.
All features
| Model Part Number | 2000066 |
|---|---|
| Brand | PRIMA CLASSIC |
Extended Product Information
FAQs
What pipe materials is this reducer compatible with?
This fitting is compatible with copper, brass, and suitable plastic pipes that meet the 15mm and 10mm standards.
Is this fitting safe for drinking water?
Yes, the Prima Classic Compression Reducer is WRAS approved, making it safe for use in potable (drinking) water systems.
Can I use this fitting for gas lines?
Yes, these fittings are suitable for gas installations, provided they are installed in accordance with all relevant local regulations and standards.
What does EN 1254 standard mean?
EN 1254 is a European standard that specifies requirements for copper and copper alloy fittings used in plumbing systems, ensuring quality, performance, and safety.
How do I tighten the compression nut correctly?
After hand-tightening the nut, use two wrenches to tighten it approximately 3/4 to 1 full turn. Avoid over-tightening, which can damage the fitting or pipe.
What is the primary function of this fitting?
Its primary function is to reduce the pipe size from 15mm down to 10mm, allowing connections between pipes of these different diameters.
Troubleshooting
Leak at the connection
Ensure the pipe is fully inserted and the compression nut is tightened sufficiently (typically 3/4 to 1 full turn after hand-tightening). Check that the olive is correctly seated and not damaged. Ensure pipes are clean and de-burred.
Difficulty inserting pipe
Verify that the pipe end is cut squarely and has not been deformed. Ensure there are no internal obstructions or burrs within the fitting or on the pipe end.
Fitting does not seal properly after tightening
The pipe may be slightly out of round, or the olive may not be making consistent contact. Try slightly rotating the nut while tightening. If the problem persists, the fitting or pipe may be defective and require replacement.
Pros and Cons
Pros
- WRAS approved for safe drinking water applications.
- Manufactured to EN 1254 standard for quality assurance.
- Durable brass construction ensures a long service life.
- Provides a secure and reliable compression joint.
- Offers excellent value for trade and DIY use.
Cons
- Only suitable for reducing from 15mm to 10mm pipe sizes.
- Requires appropriate tools for compression fitting installation.
- Not suitable for applications exceeding specified pressure or temperature limits.
- Brass fittings may require occasional checks for tightness over time.
Setup, Compatibility & Care
Setup:
- Ensure both the 15mm and 10mm pipes are cut squarely and are free from debris or damage.
- Slide the compression nut onto the pipe, followed by the olive (if separate).
- Insert the pipe fully into the corresponding end of the reducer fitting.
- Slide the nut up to the fitting and hand-tighten.
- Using two wrenches, tighten the nut an additional 3/4 to 1 full turn to create a secure seal. Avoid over-tightening.
Compatibility:
- Compatible with standard copper, brass, and plastic pipes conforming to the specified dimensions (15mm and 10mm).
- Suitable for both hot and cold water systems, as well as low-pressure gas applications (ensure compliance with local gas regulations).
Care:
- No specific maintenance is usually required for brass compression fittings under normal operating conditions.
- Periodically inspect connections for any signs of leakage, especially if the system experiences significant temperature or pressure fluctuations.