Metsä Wood - Smooth Planed Whitewood Spruce Stick Timber - 2.4M - 70mm - 27mm

While treated, it's generally recommended to avoid direct, prolonged ground contact for extended life. For critical ground contact applications, use timber specifically rated for such use (e.g., UC4 class).

Yes, you can paint or stain this timber. For outdoor use, ensure you use products suitable for exterior treated timber. For interior use, standard wood paints or stains are fine. Always ensure the timber is clean and dry before applying any finish.

For outdoor or damp environments, use corrosion-resistant fixings such as galvanized or stainless steel screws or nails. For internal, dry applications, standard timber screws or nails are suitable. Pre-drilling pilot holes is recommended.

The timber is treated, but for children's play areas, it is advisable to check the specific treatment type with the manufacturer if concerns exist about direct skin contact. Often, a protective non-toxic finish is applied after construction.

Each stick of Metsä Wood Smooth Planed Whitewood Spruce Timber (L2.4m x W70mm x T27mm) weighs approximately 2.27kg.

No, this timber is specified for non-structural internal work and general fencing/garden projects. It is not suitable for structural applications like decking joists, which require specific strength ratings and larger dimensions.

You can use a hand saw or a circular saw for cutting this timber. Always wear safety glasses and gloves. Measure accurately and mark your cutting line clearly before making the cut.

'PSE' stands for Planed Square Edge. It means the timber has been machined on all four sides to give it a smooth, consistent finish and precise square edges, making it ready for immediate use without further preparation.

This can happen due to improper storage or exposure to moisture. Ensure timber is stored flat in a dry, consistent environment. For minor warping, try clamping it straight while fixing, or cut out the warped section.

Ensure your cutting tools are sharp. When fixing, pre-drill pilot holes, especially close to the ends or edges, to prevent splitting. Use appropriate drill bit size for your screws.

Ensure the timber surface is clean, dry, and free from dust or grease. The timber might have residual treatment compounds; allow adequate drying time after installation before applying finishes. Light sanding can improve adhesion.

While treated, no timber is immune to extreme conditions. Ensure good drainage around outdoor structures. Consider applying additional protective coatings regularly. Remove and replace severely damaged sections.

Always measure twice and cut once. Use a sharp pencil and a reliable measuring tape. Account for blade kerf when making precise cuts.