Safeguard SDS Drill Bit - 12mm x 300mm

This drill bit requires an SDS drill.

Follow the Dryzone or Dryrod product instructions for the recommended hole spacing.

This drill bit is designed specifically for drilling into mortar courses. Use with other materials may damage the bit.

After use, clean the drill bit with water to remove any mortar or debris. Dry it thoroughly before storage.

The drill bit can drill through walls up to 9 inches thick (300mm).

Stop drilling immediately and try reversing the drill slowly to remove the bit. If that doesn't work, carefully use a pry bar to remove the drill bit. Contact a professional if you're unsure.

Stop drilling immediately. Try reversing the drill slowly to remove the bit. If this doesn't work, carefully use a pry bar to remove the drill bit.

Check the drill bit for damage or wear. Ensure the SDS drill is set to the correct mode for masonry. Ensure you are applying sufficient pressure during drilling.

Verify that you are using the correct 12mm drill bit and that it is fully inserted into the drill chuck. Check for wear on the drill bit.