Laminate Flooring Installation Kit - Masterworx

This kit is suitable for laminate, vinyl, engineered wood, and hardwood planks. It is not designed for tiles or solid wood.

Use the included spacers to create a uniform gap between the flooring and all vertical surfaces like walls, cabinets, and door frames. The typical gap is 8-10mm, but always refer to your specific flooring manufacturer's recommendations.

Yes, the kit is designed to assist DIYers. However, reviewing installation guides or videos for your specific flooring type beforehand is recommended for best results.

The pull bar is used to draw the last board in a row tightly against the previous one, especially in confined spaces where a mallet cannot be used effectively.

Wipe down the mallet, pull bar, and tapping block with a damp cloth after use and store them in a dry location.

The included spacers are generally reusable, but it's advisable to inspect them for damage before each use and replace any that are cracked or deformed.

Ensure the tapping block is used correctly on the side of the plank, not the end, and that the pull bar is securely hooked onto the edge of the board. Check that the spacers are not too thick, preventing the boards from closing.

Ensure the tapping block is oriented correctly (often with a bevel facing the tongue of the board) and that the mallet is striking the block squarely, not at an angle. Clean any debris from the tapping surfaces.

Verify that you are using the correct side of the double-headed mallet, typically the softer rubber side for tapping. Ensure you are striking the tapping block directly, not the flooring plank itself.