Power-TEC Flat U Type Staples - 0.8mm - 100 Piece Sets - 92553

These staples are designed for general plastic repair when used with the Power-TEC Plastic Repair Kit. For best results, test on a small, inconspicuous area of the plastic material first to ensure compatibility and adhesion.

No, the staples are designed for single use during the plastic repair process. They are permanently embedded into the plastic to provide reinforcement.

Each set contains 100 pieces of 0.8mm flat U-type alloy wire staples.

These staples are optimized for the Power-TEC Plastic Repair Kit (Part No. 92549). While they might physically fit in some other tools, performance and compatibility are not guaranteed.

U-type flat staples are designed to sit flush or slightly recessed into the plastic surface, providing strong reinforcement across a crack without protruding excessively. The flat design offers a broad contact area for better adhesion.

Store the staples in their original packaging in a dry, cool place, away from direct sunlight and moisture.

Ensure the plastic repair tool is adequately heated according to the tool's instructions. Check that the staple is correctly seated in the tool's applicator.

Verify that the staple is fully heated. If plastic is too thick or dense, it may require more heat or a different staple type. Ensure the staple is not being forced.

Confirm that enough staples are used to provide adequate reinforcement. Ensure staples are placed correctly across the break and properly melted into the plastic.