Timco Plastic Insulation Fixings - White - PIF70

The diameter of the fixing is 8.0 mm.

The length of the fixing is 70 mm.

These fixings are designed for use with concrete and masonry substrates.

The required drill hole diameter is 8.0 mm.

The minimum drill hole depth is 50 mm.

While these fixings are versatile, ensure compatibility with the specific insulation material you are using. Check the manufacturer's recommendations.

If a fixing breaks, remove the broken piece and try again with a new fixing. Ensure you are using the correct drill bit and applying the correct amount of force.

Check if the drill hole depth is sufficient. Ensure the fixing is fully inserted and that the insulation is properly aligned. Consider using a fixing with a larger head if necessary.

Ensure the drill bit is sharp and appropriate for the substrate material. Avoid excessive force during installation.

Clear any debris from the drilled hole. If the hole is too small, slightly enlarge it using the drill bit.