RUBI CEV SuperPro Diamond Blade - 180mm

This blade is designed for general cutting of all ceramic wall and floor tiles, including porcelain.

The maximum recommended RPM for the CEV 180 Superpro blade is 8500 RPM.

While not explicitly stated, continuous rim blades are generally used with a water supply in tile saws to keep the blade cool and reduce dust. Always refer to your power tool's manual for specific recommendations.

The continuous rim provides a smoother cut with less chipping, resulting in a cleaner edge finish, especially important for delicate ceramic and porcelain materials.

RUBI's SUPERPRO blades are designed to offer the best finish and are ideal for the most demanding jobs, balancing durability with cutting quality.

The CEV 180 Superpro is optimized for ceramic and porcelain tiles. For natural stone, a blade specifically designed for that material would likely yield better results and longevity.

Blade lifespan depends heavily on the materials being cut, cutting technique, and proper care. The durable diamond grain and bond alloy contribute to longevity for general ceramic applications.

Ensure the blade is mounted correctly and rotating in the proper direction. Check for excessive wear on the diamond rim. For very hard tiles, a slower speed might be needed, or consider a specialized blade if the material is beyond general ceramic.

Verify the blade is a continuous rim type (CEV Superpro is). Ensure the tile is properly supported and that you are not forcing the cut. Slow down the feed rate and allow the blade to do the work. Make sure the water supply (if applicable) is adequate to keep the blade cool and lubricated.

The material being cut may be harder than standard ceramic or porcelain. Ensure the blade is kept cool with adequate water flow. Periodically 'dress' the blade by cutting into a softer abrasive material (like concrete or brick) to expose fresh diamond segments.