Setup, Compatibility & Care
Setup:
- Vehicle Preparation: Ensure the engine is cool. Gather necessary tools: wrench for the filter, oil drain pan, new oil, and the new Bosch 0986452041 oil filter.
- Drain Oil: Locate the oil drain plug, place the drain pan beneath it, and remove the plug to drain the old oil.
- Remove Old Filter: Locate the old oil filter. Using the wrench, unscrew and remove the old filter.
- Install New Filter: Lightly lubricate the gasket of the new Bosch filter with fresh oil. Screw the new filter into place by hand until the gasket makes contact, then tighten it according to the filter's instructions (usually about 1/2 to 3/4 turn).
- Refill Oil: Replace the drain plug and refill the engine with the correct type and amount of oil, as specified in your vehicle's manual.
- Check for Leaks: Start the engine and let it run for a few minutes. Check for any leaks around the filter and drain plug.
Compatibility:
This filter is compatible with:
- Mitsubishi Outlander (Mk2, Mk3) with 2.0, 2.4, 2.2D, and 2.3D engines (2006 onwards).
- Fiat 500 312 1.2 (2007-2010) with engine code 169A4.000.
Verify compatibility with your vehicle's specific engine before purchase and installation.
Care:
- Replace the oil filter at the intervals recommended in your vehicle's service schedule.
- Always use the correct type and amount of oil.
- Dispose of the used oil and filter responsibly, following local regulations.