SNOWDON Wall Panelling Kit - Wpkt6

One kit covers approximately 2.49 square meters. Measure the area you wish to panel and divide by 2.49 to estimate the number of kits required. Always round up to ensure you have enough material.

Yes, the panelling can be painted. It is recommended to prime the surface first for best results and durability. Use a good quality interior paint.

You will need a tape measure, pencil, spirit level, saw (for custom cuts), hammer or nail gun, and possibly a mitre box. Adhesive, nails, or screws are also required for attachment.

While the kit can be used in these areas, it's essential to ensure proper sealing and ventilation, especially in high-moisture environments like bathrooms. Ensure the finish is resistant to humidity.

Clean the panelling using a soft, damp cloth. Avoid harsh chemicals or abrasive materials that could damage the finish.

The kit includes: 1 x 2.4m Decorative Capping Moulding (82 x 9mm), 1 x 2.4m Decorative Face Moulding (63 x 9mm), 1 x 2.4m Horizontal Top Strip (82 x 9mm), 1 x 2.4m Horizontal Bottom Strip (63 x 9mm), 7 x 881mm Vertical Strips (63 x 9mm), and 6 x 327mm Horizontal Infill Strips (63 x 9mm).

Ensure the wall is properly prepared (clean, dry, and smooth). Use a strong wood adhesive or appropriate fixings. If using adhesive, ensure adequate pressure is applied while drying.

Use a fine-tooth saw and a mitre box for straight or angled cuts. Ensure your cutting tools are sharp for a clean finish.

Use a spacer tool or measure and mark consistent intervals on the wall before starting installation. Double-check measurements for accuracy.

Ensure the surface was properly primed before painting. Use a high-quality paint suitable for wood or MDF and apply thin, even coats. Lightly sand between coats if necessary.