Trend Intumescent Router Cutter - 10mm x 24mm

The Trend Intumescent Router Cutter creates a groove that is 10mm x 4mm, designed for standard intumescent strips.

This cutter is compatible with routers that accept a 1/4in shank.

Use the 'K' mark on the cutter as a guide to set the appropriate depth for the intumescent strip.

Clean the cutter regularly to remove resin buildup. Sharpen or replace the cutter when it becomes dull.

Always wear eye and ear protection when using the router cutter. Ensure the router is securely mounted and use appropriate feed rates.

The PTFE coating minimizes heat and resin buildup, enhancing the cutter's performance and longevity.

This cutter is suitable for various wood types commonly used in door and frame construction. However, always test on a scrap piece of wood first.

Ensure the bearing guide is properly seated against the edge of the door or frame, and that the router is stable during operation. Check for any obstructions.

Check the cutter for damage or dullness. Replace the cutter if necessary. Ensure the feed rate is appropriate for the wood type.

Verify that the cutter is the correct model (C209X1/4TC). Check the router depth setting to ensure it is set correctly.

Reduce the feed rate. Ensure the cutter is sharp and clean. Consider using a different wood type or a slower router speed.