Mini Moto EasyStart Silver Pull Start Pullstart Flywheel Minimoto Quad Bike - PetrolScooter

This kit is designed for 'Chinese air-cooled minimoto or pocket bikes'. While it should fit many, it's essential to verify the flywheel dimensions (Outer Diameter: 98.38 mm / 3.87 inches, Height: 47.63 mm / 1.88 inches) against your existing one to ensure compatibility.

No, this Mini Moto EasyStart kit includes the pull start mechanism and the flywheel only. You will need to reuse your existing starter clutch or purchase one separately if required.

Installation requires basic mechanical knowledge. You will need to remove the old pull start and flywheel and install the new ones. It typically involves a few bolts and ensuring proper seating of the flywheel.

You will likely need basic tools such as wrenches or sockets to remove the flywheel nut and any mounting screws. A flywheel puller might be necessary in some cases, though many minimoto flywheels can be removed with a pull start. Refer to specific service information for your model if available.

While replacing just the cord is sometimes possible on some pull starts, this product is a complete pull start and flywheel assembly. If your old pull start is broken, this kit provides a full replacement for both the pull start mechanism and the flywheel.

Warranty information is typically provided by the seller. Please check the listing details or contact the seller directly for information regarding warranty coverage.

This pull start is designed for 'air-cooled' engines, which typically implies 2-stroke engines commonly found in minimotos. It is generally not intended for 4-stroke engines unless specifically stated otherwise for a particular model.

The internal spring mechanism may be obstructed or damaged. Ensure no debris is caught. If the issue persists, the pull start may need replacement.

Check that the pull start mechanism is properly engaging the flywheel. Ensure the flywheel is securely attached to the crankshaft and not spinning freely. Verify that the starter clutch (if applicable and reused) is functioning correctly.

The flywheel nut or mounting bolts may be loose. Remove the pull start, tighten the flywheel securely to the crankshaft (refer to torque specifications if available), and then reinstall the pull start.

Double-check the compatibility requirements. Ensure you have an air-cooled Chinese minimoto or pocket bike and that the flywheel dimensions (Outer Diameter: 98.38 mm, Height: 47.63 mm) match your engine's specifications.